Swordfishing Fort lauderdale Style

I was laying down on the bow of the boat gazing at the brilliant stars on this moonless night. All of the rods were set out, staggered by depths and distance away from the boat. As we all were enjoying ourselves on this night away from the anxieties of life, we listened to the clickers make there familiar tunes as the waves picked us up and put us back down. I prefer to keep to keep the drags loose, clickers on and then tighten up after the strike. All of the rods sounded alike going click,--- click,--- click... I got up from the bow and said, "something don't sound right". One of the rods was going a bit faster, click, click, click. It was like a shark bite, steady and slow. I ran over to the rod and put the drag lever in the strike position and waited for the fishes turn. Within a few seconds the rod tip bent over, and I yelled "We got one!" I cranked hard and fast and then the rod really doubled over but this fish still didn't take any drag. I don't think the fish knew there was a hook set in him. I tried to crank some more but the spool stood still with the rod bent over. Within a split second we got the reaction of a lifetime. The drag started slipping like we hooked on to a locomotive and would not stop. It seemed to go on forever as the line quickly disappeared off the Penn 80 TW, it looked like we were going to get spooled. We were fishing in about 1,400 feet of water and it looked like we had about that much line out. With less than half the line left the heated drag started slowing down. Now it was our turn. "The bent butt rod stays in the rod holder" I said to the rod man, "just crank the best you can and keep that rod tip bent at all times keeping consistent pressure on the fish". We were able to get about 3 quarters of the spool back when our fish decided to make another locomotive run. This fish took what he wanted, when he wanted. We were in for a big battle. Paying close attention is crucial during this fight, because pressure has to be kept on this fish 100 % of the time. Three people are on this boat and we each got about 5 turns to crank this baby in as we could only last no more than 15 minutes each. Over three hours later then I stuck a large flying gaff into a Broadbill Swordfish estimated over 300 lbs. This is what world class Sword fishing is all about.

The following are some tips from me, the Captain, on rigging for this night excursion:

Boat rigging:

You will need a seaworthy boat, either chartered or owned, All running lights need to be in working order; Port, Starboard, and Stern lights. These lights are mandatory and very important since there are shipping lanes in our fish zone. You must be able to identify and be identified when you're on the water at night. Knowledge of vessel lights is important so as to avoid a collision course. Keep all loose articles either tied down or in a locker as you make the long run offshore. Always do manual checks on your bile pumps. I take a hose and start filling up the bilge. If your float switches are working the bilge pumps will come on automatically and you're ready to roll.

Fishing line:

800 yards of 50 pound test should get most jobs done. Most guys are going with the braided lines which have a smaller diameter than monofilament does and have double the strength. As an example we have used 200 lb. braided Tuff line which has a diameter of 50 lb. test mono, therefore we can spool over 1000 yards on to a Penn 80TW. This might sound overkill but I like to fish all my rods ready for that 400 pounder.

Reels:

50 weight reels such as Finore, Penn, and Shimano's 2-speed are the preferred minimum. If you size down you take a risk of getting spooled or the drag might not hold up against the pressure. It can be done but it takes good skill. The Broadbill Swordfish has been known to reach over 1000 pounds, but more common in the 100-200 pound range.

Rods:

A nice short stick in the 50 -80 pound class is an awesome rod. A bent butt rod is my choice for handling a big fish. Extra large Aftco roller guides are some of the best guides to have and play an important role when line strips off the reel. They help to keep your wind-ons from getting damaged.

Leaders:

To start, wind-on leaders should be used and can be purchased at most offshore tackle shops. They help when your fish comes close to the boat and does not want to cooperate. The extra length of heavy mono will safeguard your line when it chafes on the bottom of your boat or goes around the props. A 40 turn bimini needs to be tied to the end of your main line, then connect the loop that is on your wind-on to the loop on your bimini by taking your wind-on loop and insert it through your bimini. Then take the tag end of your wind-on leader and pass it through the wind-on loop 2 times, then pull tight. Next you need to connect a 300 lb. strength ball-bearing swivel or better to the end of the wind-on using a crimp that matches your line strength. I use 300 pound leaders with the crimps to match and also chaffing gear to reduce any wear and tear to the leader connections.

Now you need to connect 8-10 feet of the same strength leader to the other end of the ball-bearing swivel. Don't forget the chaffing gear.

Hooks:

You are near the final stages. Size 10/0 Mustad hooks are the average and are worthy. The following are 2 single hook rigs:

The first one is easy and used for live bait. Just crimp your hook, (use chaffing gear) to the end of the leader. Keep your loops small as you crimp the hook, but big enough so that the hook swings freely. Live baits should be bridled through the eye sockets and not through the eyeballs. I use 50 pound strength wax line with an open eye needle for bridling. Then I insert the hook upwards under the bridle.

The 2nd rig is a squid rig. It is almost like the first except you use 2 crimps. Pass the first crimp through the tag end so it slides freely then crimp your 2nd one the same way as the live bait rig, only this time leave about 2 inches of the tag end pass through the crimp. Next take your medium to large squid and insert the hook about ¾ of an inch down from the top of the mantle and pull through past your crimp and extra tag line. Then take your free moving crimp and bring it down and insert that extra tag line into the crimp, but do not crimp down on it. This will hold up your squid as if on a coat hanger. Then you will need to re-insert the hook back through the squid making sure the squid hangs straight when all is finished. Next take your bridling needle and floss and sow the squids head and tentacle section to the mantle piece. This section is delicate on the squid and might even pull off. Making sure everything looks normal to the fish is important. Using the needle and thread will make the squid stay intact on the strike.

Accessories:

As you prepare to deploy your lines you will need a supply of 12-32 oz weights, light sticks, balloons and rubber bands. The first line to be set out will be the furthest from the boat and also the deepest, 250-350 feet deep. First things first, crack your light stick or twist your Electralume and attach it to your leader with a wax line loop tied on your line anywhere from 10-40 feet away from the bait. Then rig your bait as we did earlier. Throw your bait overboard and go at least 20-50 feet behind the bait to attach your weight by using another wax line loop. Make this connection tight so the weight does not slide around the line. The heavier the weight the faster your bait pulls through the water. Heavier weights for dead baits like Squid, Bonita and small Mackerel and lighter weights for live bait like Blue Runners, goggle eyes, Tinkers etc.

Set your first jug or balloon far from the boat, at least 200 feet away with a cylume attached for a good visual. You're ready for rod # 2. This rod will go 2-250 feet down, then attach your balloon or jug and set this line in between the boat and the furthest balloon. Space the balloons about 100 feet apart. Your next rod will go down 150-200 feet. To avoid all the counting I will pre-measure my lines at home and mark them by tying half hitches with wax line. This way when you deploy your lines, just let out the line slowly until you reach your marker. This last rod does not need a balloon, it is fished right below the boat. If you use more rods you need to set your first balloon further from the boat, and perhaps a 2nd rod at the boat, one on the bow, one on the stern.

It is a good idea to get an under water light that can be kept right under the transom. This light will attract fish, and you can see passing Turtles, Dolphin and other baits come right into the light looking for something to eat and sometimes even a Swordfish will swim through.

Prior to all the rigging, the most important part is to set your drags. With 50 pound line, 8-10 pounds of drag is sufficient at the strike drag position. With heavier lines, 12 pounds of drag is more than enough. The lower jaw on the Swordfish is very soft and if a hook gets lodged in that section it will pull when under enough pressure. If the hook gets lodged in the upper section you can use more drag, but you never know where he's hooked so stay light on the drag and bring that fish to the boat. Shimano's drag scales are a great tool for measuring your drags.

Your final step is to tune your drag levers after you deploy each line. Some Captains prefer to keep their drag lever in the strike position I prefer to keep them loose with the clickers on, just enough so you don't hear the line pay out when the waves lift the boat up and down.

You are now Sword fishing!

Remember there is a size limit of 47 inches from the tip of the lower jaw to the fork of the tail. There is nothing wrong with releasing fish bigger than 47 inches either. Sinking a gaff into a fish near 200 pounds or better is a much better accomplishment.

If you would like to see it all firsthand contact Captain Cary Hanna @ captcary@newlattitude.com to take you out for this deep sea adventure.

Captain Cary Hanna is a USCG certified boat captain. He runs his charter boat, the 'New Lattitude' out of the Port Everglades inlet in Ft. Lauderdale, Florida. and has logged over 200 trips fishing for Swordfish. The Captains' boat is a custom rigged 2004 32 foot Donzi center console powered with twin 225 hp Mercury Optimax's. To reserve a charter or ask any questions about this article call 954-907-0967.

Till Next Tide,

Captain Cary Hanna

http://www.newlattitude.com Fort lauderdale Sportfishing Charters Swordfish, Sailfish, Dolphin, Tuna, Kingfish, Sharks and more. Come Get Some

---

Back To Fish School....Baitfish 101

Class Is In Session.... Baitfish 101Okay.So you would think that... Read More

Tastes Like Chicken!

For the most part, I am an advocate for catch... Read More

Erie Steelhead Flies

As we stated in our article on Pacific Steelhead flies,... Read More

My Fishing Trip With The Pro

I was in Southwest Florida and was asked to go... Read More

Fly Fishing for Saltwater Salmon with Surface Flies

One of the greatest thrills in Pacific Northwest fly fishing... Read More

A Technique To Catch Trophy Size Bass

There is a craze going on that produces big bass,... Read More

Choosing the Right Fly Fishing Rod

Choosing a good rod is a major decision for the... Read More

Fly Fishing Journals ? Keep Track of Your Trips

Fly fishing is addictive. Once you start, you'll never stop.... Read More

Ever Said: We Should Have Caught Bass By Now?

Have you ever been on a lake and thought to... Read More

Concentrate on Your Fishing

I was watching a TV Show with Bill Dance and... Read More

Communications Equipment in the Wilderness

For Hunting, fishing, hiking, boating or cycling in all kinds... Read More

Challenges of Nymph Fly Fishing

When nymph fly fishing, the angler is imitating the juvenile... Read More

The Joys of Trout Fishing

The thrill of trout fishing! It is the best, isn't... Read More

What Has Happened to the Cod Stocks Off the Shores of Newfoundland?

The Newfoundland cod stocks. What has happened to cod fishing... Read More

Do You Know How To Clean A Fish?

Now that you have caught your dream fish, do you... Read More

Three Main Trout Senses

An angler should therefore become familiar with the three main... Read More

Tips To Getting Sponsored For Fishing Tournaments

One of the most important steps in getting sponsored to... Read More

Why Do I Fish?

As part of an email discussion list I'm part of,... Read More

Fly Fishing Secrets for the Novice as Well as the Seasoned Angler

Perhaps the most rewarding element of fly fishing is the... Read More

Understanding the Effects Moonlight on Swordfishing

In order to better understand why swordfish concentrate their feeding... Read More

Fishing Fall Bass - Early Fall Fishing for Bass in the Northwest as the Seasons Change

You have just rolled out of bed, poured you coffee... Read More

What You Need To Know Before You Sell Your Boat

As the owner/operator of a full service boat detailing-yacht maintenance... Read More

Catch Your Limit With These Fishing Supplies

Great fishing supplies are an essential when it comes to... Read More

Choosing Steelhead Gear

Steelhead GearLike many things in fly fishing you can ask... Read More

The Yellowfins from HELL!

Hi Lee Palm/Red Rooster crew(San Diego - California).. Keep my... Read More