How to Remove Your Mk2 Mini Moto Engine

Many mini moto modifications will require you to remove the engine from the mini moto. This is why I have produced the following guide.

Firstly you will need to remove the mini moto's fairing.

Start with the seat fairing, unscrew the four seat screws and remove the seat. Unscrew the screw at the front end of the seat fairing and remove the petrol cap. The fairing can now be lifted from the mini moto. Replace the fuel tank petrol cap and remove the fuel tank by pulling the rubber tube of the nipple on the top of the carburettor. You may want to double the rubber fuel tube over and secure it in this position with a clothes peg. This is to stop fuel leaking out.

Remove the bottom fairing by unscrewing the holding bolts (two on each side), this frees the bottom fairing from the top. Unscrew the two bolts on the underside of the bottom fairing. The bottom fairing is now free. The top fairing is only now held on by one last bolt located in between the handle bars at the front of the mini moto.

Once you have removed the fairing, you will need to take the chain off the front sprocket. To do this loosen the back wheel nuts and the tensioning bolts. The back wheel can now be manoeuvred toward the front sprocket loosing the chain. When the chain is loose enough you can remove it from the front sprocket.

Remove the pull start from the engine by unscrewing the three holding screws. Once the pull start has been removed you will see the wire that comes from the stop switch. Unplug this.

The throttle cable can be removed from its fitting on the top of the carburettor. Pull the rubber seal up so that the locking nut can be unscrewed, the throttle can now be pulled from the carburettor along with the needle valve and spring.

The next step is to Remove the Exhaust. The exhaust is fixed to the mini motos frame by a bolt located just under the seat fairing toward the back of your mini moto. Undo this bolt with a spanner and an alan key. The exhaust is fixed to the underside of the engine by two bolts via a gasket. Remove the two bolts with an alan key making sure that you do not lose the gasket washer. The exhaust can now be slid out past the engine and removed form the mini moto.

The engine is free from its mechanical fittings, the engine then needs to be removed from the mini motos frame. The bolt at the top of the engine must be undone first using the alan key. The three screws located on the underside of the engine are the last fixings to be undone. The engine can now be completely removed from the mini moto.

Matt Tong has been importing and riding Mini Motos for two years. For expert advice and Mini Moto information please visit http://www.minimotosandmore.com

---

Honda Super Cub and 50cc Honda Cub - The Volkswagen Beetle of Motorcycles!

A very clever design: the Honda Super Cub was the... Read More

Take Care of Her and Shell Do the Same ( How to start out the riding season)

Has your scoot been sitting in the garage all winter,... Read More

The Buzz is All About Mini-Motorcycles

Pocket bikes are miniature motorcycles -- powered, for the most... Read More

Auctions and Car Transport: Everything You Need To Know

Everyone has wanted to sell a car at some point... Read More

Women and Motorcycles? You Bet!

To really understand the women and her ride, one needs... Read More

Trackdays - Get the Maximum Enjoyment from Your Time on the Track

Many motorcyclists want to take their bikes onto the track... Read More

Mini Moto Mayhem

Mini Motos have been around in the UK for around... Read More

Suzuki Motorcycles - From Fine Loom Manufacturers to Major Motorcycle Company

Started in a small warehouse by Michio Suzuki back in... Read More

Minimoto Dirt Bikes, Miniture Motards - The Next Step Up from Battery Powered Toys

As your child grows out of their little bicycle and... Read More

Motorcycle Radar Detectors

Standard radar detectors were not built for motorcycles and were... Read More

Motorcycle Tires - Why Should You Care?

One of the most important parts of any vehicle is... Read More

Mini Moto Tips

These are some quick adjustments and tips for the B1... Read More

0 to 60 in 4.5 Seconds

Speeding is illegal, yet we sell racing motorcycles and cars... Read More

Motorcycle Suspension: - A Troubleshooting Guide

Trouble Shooting Suspension Problems.Adjustment locations: ForksRebound adjustment (if applicable) is... Read More

A Convenient Way to Slash Your Gas Bill

"With oil prices spiraling higher almost every day, people are... Read More

How to Remove Your Mk2 Mini Moto Engine

Many mini moto modifications will require you to remove the... Read More

How Do You Make Your Harley Davidson Look And Feel Like An Extension Of Yourself!

How do you make your Harley Davidson look and feel... Read More

So You Want To Be A Custom Bike Builder? Start With A Motorcycle Kit!

So you want to be a custom bike builder? Well... Read More

It?s One Thing for People to Buy Your Product or Service, but It?s Another for Them to Tattoo Your

William Harley and Arthur Davidson, both in their early twenties,... Read More

Necessity of Motorcycle Parts

If you are one of the many people who consider... Read More

Ride Hard - Hydrate Harder

This summer is showing all of the signs of being... Read More

Motorcycle Accidents: Preparing Your Case

Motorcycle accident is an unexpected occurrence that results to shock... Read More

Ghost Minimoto Moto GP Reps ? What Are They?

What are Mini moto's? A Minimoto is a miniature version... Read More

Save Money on Used Motorcycle Parts

For every motorcycle enthusiast, it is indeed very taxing to... Read More

Motorcycle Suspension Setup: Getting to Grips with a Black Art

Suspension Set-up: The basicsWhether you are a road rider or... Read More